Runs or Sags

Runs or Sags

Runs or sags

 

 

 

 

Cause:

  • Heavy paint build up due to incorrect spraying viscosity, spraying technique, flash off times between coats and film thickness
  • Defective spraygun nozzle or incorrect spraying pressure
  • Temperature of the paint, substrate or spraybooth too low
  • Incorrect choice of hardener and thinners

 

Prevention:

  • Follow application recommendations on the Protec technical data sheets
  • Ensure that your spraygun is in good working order
  • Warm object and keep room temperature above 20ºC.

 

Rectification:

  • After topcoat has hardened thoroughly, remove the runs and sags using a tungsten block and sand paper then polish with approved cutting compound
  • Sand and respray if necessary.
There are no products to list in this category.