PC-3900 Paraglaze Extra Flow Clearcoat - 2 Pack
PC-3900 PARAGLAZE EXTRA FLOW CLEARCOAT is a two pack acrylic urethane clearcoat designed for high flow and high clarity. It is designed to be used for multi panel work and overall repairing. It is formulated to give optimum gloss and durability when used over 706 PARAGLAZE BASECOAT.
SUBSTRATES & PREPARATION
Paraglaze Extra Flow Clearcoat must be applied on top of a clean and dust-free 706 Paraglaze Basecoat. The use of a clean tack rag is recommended to remove dust from the basecoat film before clearcoating.
- Fully cured 2 pack refinish clearcoats that have been degreased and sanded.
- Sound Automotive OEM clearcoats that have been degreased and sanded.
Substrates other than those stated should be tested before use to ensure that the performance of the product is suitable for its intended use.
MIXING RATIO BY VOLUME
PC-3900 PARAGLAZE EXTRA FLOW CLEARCOAT 2 Parts
PH-4200 or PH-4300 HARDENER 1 Part
PS-6100 or PS-6200 or PS-6300 REDUCER 10%
POTLIFE - 1 hour at 20oc
SPRAY VISCOSITY @ 20oc - 17-19 Seconds (DIN4)
SPRAYGUN SETUP
Nozzle 1.3mm - 1.4mm
Spray Pressure - HVLP/RP 2-3 bar
Spray Pressure - Conventional 45-55 PSI / 300-380 KPA
NUMBER OF COATS & FLASH OFF
1st Coat Apply an even medium coat
Flash Off Flash off for 5-7 minutes @ 20oc
2nd Coat Apply an even wet coat
DRYING TIMES
Bake Temperature 65oc (metal temperature)
Bake Time 40 minutes
TOTAL DRY FILM BUILD 50-60 um
OVERCOAT / RECOAT PREP P500 Dry or P800 Wet after baking
OVERCOAT / RECOAT TIME Minimum 8 hours after bake
DE-NIBB & POLISHING Remove dirt if required using P1500 grit wet abrasive, then cut & polish using your preferred products
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
