CP-6120 Carmaster 2 Pack Hi Build Primer Filler

CP-6120 Carmaster 2 Pack Hi Build Primer Filler
CP-6120 Carmaster 2 Pack Hi Build Primer Filler CP-6120 Carmaster 2 Pack Hi Build Primer Filler CP-6120 Carmaster 2 Pack Hi Build Primer Filler
Brand: Protec
Product Code: CP-6120
Availability: In Stock
   - OR -   

CP-6120 CARMASTER 2 PACK HI BUILD PRIMER FILLER is a two pack acrylic urethane high build primer designed for use as a general smash quick drying high build filler that is easy to sand.  It can also be thinned and used as a primer surfacer, it offers excellent film build, sanding and gloss holdout. For large areas of bare metal use PROTECH ETCH or EPOXY PRIMER under Carmaster 2 Pack Hi Build Primer Filler.

SUBSTRATES & PREPARATION

  • Fully cured 2 pack refinish coatings that have been degreased and sanded.
  • Sound Automotive OEM coatings that have been degreased and sanded.
  • Small areas of bare metal that have been degreased and sanded.
  • Electrocoated new panels that have been degreased and sanded.
  • GRP Fibreglass that has been degreased and sanded.
  • Large areas of bare metal and areas where polyester body filler will be applied should be coated first with Protec Expoxy Primer AP-4110.

 

MIXING RATIO BY VOLUME

CP-6120 CARMASTER 2 PACK HI BUILD PRIMER FILLER                4 Parts

CH-5100 or CH-5200 HARDENER                                                         1 Part

CS-3800 REDUCER                                                                               10-30%

 

POTLIFE - 1 Hour at 20oc

 

SPRAY VISCOSITY @ 20oc - 19-24 Seconds (DIN4)

 

SPRAYGUN SETUP

Nozzle                                           1.6mm - 1.8mm
Spray Pressure - HVLP/RP           2-3 bar
Spray Pressure - Conventional     45-55 PSI / 300-380 KPA

 

NUMBER OF COATS & FLASH OFF

1st Coat                   Apply an even medium coat
Flash Off                   Flash off for 5 minutes @ 20oc
2nd Coat                  Apply an even wet coat
Flash Off                   Flash off for 5 minutes @ 20oc
3rd Coat                   Apply an even wet coat

 

DRYING TIMES (When topcoated)

Bake Temperature                           65oc (metal temperature)
Bake Time                                        40 minutes
IR Time                                            12-16 minutes (short wave)

 

TOTAL DRY FILM BUILD                140-180 um

 

SANDING DRY                                 Finish with no coarser than P500 Dry
SANDING WET                                 Finish with no coarser than P800 Wet

 

OVERCOAT WITH

CP-6120 CARMASTER 2 PACK HI BUILD PRIMER FILLER can be topcoated with refinish basecoats or direct gloss solid colours.

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: