AP-6000 Protec Ultraseal - 2 Pack

AP-6000 Protec Ultraseal - 2 Pack
AP-6000 Protec Ultraseal - 2 Pack AP-6000 Protec Ultraseal - 2 Pack AP-6000 Protec Ultraseal - 2 Pack
Brand: Protec
Product Code: AP-6000
Availability: In Stock
   - OR -   

Please refer to Techincal Data Sheet:

http://www.protec.com.au/images/uploads/tech_data_sheets/AP-6000_PROTEC_ULTRASEAL_Protec_Primers_16-10-15.pdf

AP-6000 PARAGLAZE ULTRASEAL is a two pack transparent sealer & adhesion promoter, it can be tinted up to 10% with 606 PARAGLAZE LINE TINTER.  Ultraseal is used in wet on wet mode only and most commonly used on new panels as an adhesion promoter over sound OEM Electrocoat.

SUBSTRATES & PREPARATION

  • Fully cured 2 pack refinish coatings that have been degreased and scuffed with a scouring pad.
  • Sound Automotive OEM coatings that have been degreased and scuffed with a scouring pad.
  • Electrocoated new panels that have been degreased and scuffed with a scouring pad.
  • GRP Fibreglass that has been degreased and scuffed with a scouring pad.
  • Large areas of bare metal and areas where polyester body filler will be applied should be coated first with Protec Expoxy Primer AP-4110.

 

MIXING RATIO BY VOLUME

AP-6200 PARAGLAZE ULTRASEAL                  3 Parts

PH-4200 or PH-4300 HARDENER                      1 Part

PS-6100 or PS-6200 or PS-6300 REDUCER      50%

 

POTLIFE - 2 Hours at 20oc

 

SPRAY VISCOSITY @ 20oc - 12-14 Seconds (DIN4)

 

SPRAYGUN SETUP

Nozzle                                           1.3mm - 1.4mm
Spray Pressure - HVLP/RP           2-3 bar
Spray Pressure - Conventional     45-55 PSI / 300-380 KPA

 

NUMBER OF COATS & FLASH OFF

1 Coat                       Apply 1 even wet coat
Flash Off                   Flash off for 15 minutes @ 20oc

 

DRYING TIMES (When topcoated)

Bake Temperature                           65oc (metal temperature)
Bake Time                                        See datasheet for topcoat product
IR Time                                            See datasheet for topcoat product

 

TOTAL DRY FILM BUILD                15-20 um

 

OVERCOAT WITH

PP-6000 PARAGLAZE ULTRASEAL must be topcoated with Protec 606 ACRYLIC URETHANE ENAMELS or 706 PARAGLAZE BASECOAT.

 

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad            Good

Enter the code in the box below: