PP-1550 Paraglaze Multiprime - 2 Pack
PP-1550 PARAGLAZE MULTIPRIME is a 2 pack urethane primer. Multiprime is mainly used as a primer surfacer or wet on wet primer, however it can also be used as a primer filler. It offers excellent surface levelling, sanding and gloss holdout. It is specifically designed for use under Protec 606 ACRYLIC URETHANE ENAMEL & 706 PARAGLAZE BASECOAT. For large areas of bare metal use PROTECH ETCH or EPOXY PIMER under Multiprime.
SUBSTRATES & PREPARATION
- Fully cured 2 pack refinish coatings that have been degreased and sanded.
- Sound Automotive OEM coatings that have been degreased and sanded.
- Small areas of bare metal that have been degreased and sanded.
- Electrocoated new panels that have been degreased and sanded.
- GRP Fibreglass that has been degreased and sanded.
- Large areas of bare metal and areas where polyester body filler will be applied should be coated first with Protec Expoxy Primer AP-4110.
MIXING RATIO BY VOLUME
PP-1550 PARAGLAZE MULTIPRIME 4 Parts
PH-4100 or PH-4200 HARDENER 1 Part
PS-6100 or PS-6200 or PS-6300 REDUCER 10-30%
POTLIFE - 1 Hour at 20oc
SPRAY VISCOSITY @ 20oc - 18-23 Seconds (DIN4)
SPRAYGUN SETUP
Nozzle 1.6mm - 1.8mm
Spray Pressure - HVLP/RP 2-3 bar
Spray Pressure - Conventional 45-55 PSI / 300-380 KPA
NUMBER OF COATS & FLASH OFF
1st Coat Apply an even medium coat
Flash Off Flash off for 5 minutes @ 20oc
2nd Coat Apply an even wet coat
Flash Off Flash off for 5 minutes @ 20oc
3rd Coat Apply an even wet coat
DRYING TIMES (When topcoated)
Bake Temperature 65oc (metal temperature)
Bake Time 40 minutes
IR Time 10-14 minutes (short wave)
TOTAL DRY FILM BUILD 130-160 um
SANDING DRY Finish with no coarser than P500 Dry
SANDING WET Finish with no coarser than P800 Wet
OVERCOAT WITH
PP-1550 PARAGLAZE MULTIPRIME can be topcoated with Protec 606 ACRYLIC URETHANE ENAMELS or 706 PARAGLAZE BASECOAT.
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
