CP-6120 Carmaster 2 Pack Hi Build Primer Filler
CP-6120 CARMASTER 2 PACK HI BUILD PRIMER FILLER is a two pack acrylic urethane high build primer designed for use as a general smash quick drying high build filler that is easy to sand. It can also be thinned and used as a primer surfacer, it offers excellent film build, sanding and gloss holdout. For large areas of bare metal use PROTECH ETCH or EPOXY PRIMER under Carmaster 2 Pack Hi Build Primer Filler.
SUBSTRATES & PREPARATION
- Fully cured 2 pack refinish coatings that have been degreased and sanded.
- Sound Automotive OEM coatings that have been degreased and sanded.
- Small areas of bare metal that have been degreased and sanded.
- Electrocoated new panels that have been degreased and sanded.
- GRP Fibreglass that has been degreased and sanded.
- Large areas of bare metal and areas where polyester body filler will be applied should be coated first with Protec Expoxy Primer AP-4110.
MIXING RATIO BY VOLUME
CP-6120 CARMASTER 2 PACK HI BUILD PRIMER FILLER 4 Parts
CH-5100 or CH-5200 HARDENER 1 Part
CS-3800 REDUCER 10-30%
POTLIFE - 1 Hour at 20oc
SPRAY VISCOSITY @ 20oc - 19-24 Seconds (DIN4)
SPRAYGUN SETUP
Nozzle 1.6mm - 1.8mm
Spray Pressure - HVLP/RP 2-3 bar
Spray Pressure - Conventional 45-55 PSI / 300-380 KPA
NUMBER OF COATS & FLASH OFF
1st Coat Apply an even medium coat
Flash Off Flash off for 5 minutes @ 20oc
2nd Coat Apply an even wet coat
Flash Off Flash off for 5 minutes @ 20oc
3rd Coat Apply an even wet coat
DRYING TIMES (When topcoated)
Bake Temperature 65oc (metal temperature)
Bake Time 40 minutes
IR Time 12-16 minutes (short wave)
TOTAL DRY FILM BUILD 140-180 um
SANDING DRY Finish with no coarser than P500 Dry
SANDING WET Finish with no coarser than P800 Wet
OVERCOAT WITH
CP-6120 CARMASTER 2 PACK HI BUILD PRIMER FILLER can be topcoated with refinish basecoats or direct gloss solid colours.
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
