CC-9240 Carmaster HS 2 Pack Clearcoat
CC-99240 CARMASTER HS 2 PACK CLEARCOAT is a high solids two pack acrylic urethane clearcoat that is specifically formulated for better flow off the gun, it provides optimum gloss and is easy to polish. It is designed to be used for multi panel work and overall repainting.
SUBSTRATES & PREPARATION
Carmaster HS 2 Pack Clearcoat must be applied on top of a clean and dust-free Basecoat. The use of a clean tack rag is recommended to remove dust from the basecoat film before clearcoating.
- Fully cured 2 pack refinish clearcoats that have been degreased and sanded.
- Sound Automotive OEM clearcoats that have been degreased and sanded.
Substrates other than those stated should be tested before use to ensure that the performance of the product is suitable for its intended use.
MIXING RATIO BY VOLUME
CC-9240 CARMASTER HS 2 PACK CLEARCOAT 2 Parts
CH-5200 or CH-5300 HARDENER 1 Part
CS-3800 REDUCER 10%
POTLIFE - 1 hour at 20oc
SPRAY VISCOSITY @ 20oc - 18-19 Seconds (DIN4)
SPRAYGUN SETUP
Nozzle 1.3mm - 1.4mm
Spray Pressure - HVLP/RP 2-3 bar
Spray Pressure - Conventional 45-55 PSI / 300-380 KPA
NUMBER OF COATS & FLASH OFF
1st Coat Apply an even medium coat
Flash Off Flash off for 5-7 minutes @ 20oc
2nd Coat Apply an even wet coat
DRYING TIMES
Bake Temperature 65oc (metal temperature)
Bake Time 40 minutes
TOTAL DRY FILM BUILD 55-65 um
OVERCOAT / RECOAT PREP P500 Dry or P800 Wet after baking
OVERCOAT / RECOAT TIME Minimum 8 hours after bake
DE-NIBB & POLISHING Remove dirt if required using P1500 grit wet abrasive, then cut & polish using your preferred products
Write a review
Your Name:Your Review: Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below:
